Accessory mounting bracket for enclosure
Commercial Type No.: D137 | Product No.: F.01U.020.521
- Mount accessory modules in B8103, D8103, D8108A, and D8109 enclosures.
Attack resistant enclosure, large
Commercial Type No.: D8108A | Product No.: 4.998.125.920
- 18 gauge cold-rolled steel enclosure
- UL Listed for Central Station Fire, Local Fire, and Remote Station Fire applications
Auxiliary relay module, 12/24VDC
Commercial Type No.: D130 | Product No.: 4.998.125.828
- 12 VDC or 24 VDC relay
- Allows switching of current or voltage
- Two non-latching Form C dry contact outputs
- Red LED shows coil is energized
- Mounts in control panel enclosure
Battery, 12V 7Ah
Commercial Type No.: D126 | Product No.: 4.998.125.825
- 12 VDC sealed lead‑acid
- Fully rechargeable
- Maintenance‑free
- For use as secondary power source
- Long service life
PRODUCT FAMILY
DS7432 Series Eight‑input Remote Modules
- Address up to eight input loops
- Serial dual end-of-line (EOL) wiring with tamper status (DS7432E)
PRODUCT FAMILY
DS7457i Series Single‑zone Input Modules
- Power-limited and supervised input zones
- Compact enough to fit within most back boxes and enclosures
- Address settings through DIP switches
Dual phone line switcher, 12V
Commercial Type No.: D928 | Product No.: 4.998.800.206
- Automatically switches to alternate phone line
- AC Power LED
- Primary and Secondary Phone Trouble LEDs
- Communication Fail LED
Enclosure lock and key set
Commercial Type No.: D101 | Product No.: 4.998.800.200
- Lock and key set fits Bosch enclosures
RPS
Programming modem, 2400 baud
Commercial Type No.: MODEM-KIT-2400B | Product No.: 4.998.800.210
- For programming communications
DS7000
Single Multiplex driver
Commercial Type No.: DS7430 | Product No.: 4.998.800.008
- Provides a two-wire multiplex bus for DS7400Xi Control Panels.
Steel enclosure for module, small, grey
Commercial Type No.: D203 | Product No.: 4.998.800.374
- Compatible with input and output modules that have 3-hole or 3-point mountings
- Compatible with Bosch 3-hole mounting modules
- Optional tamper switch mounting location
Transformer plug-in, 16V 40VA
Commercial Type No.: D1640 | Product No.: 4.998.125.832
- System transformer rated at 16.5 VAC, 40 VA
- Suitable for use on approved UL applications in the USA
CONETTIX
USB/serial interface module
Commercial Type No.: DX4010V2 | Product No.: F.01U.080.969
- RS-232/USB connectivity
- Enhanced direct connection for Remote Programming Software (RPS)
- RJ-16 data bus
- Transparent enclosure
- Diagnostic light emitting diodes (LEDs)
- DIP switches for address and bus programming
DS7000
Dual multiplex driver
Commercial Type No.: DS7436 | Product No.: 4.998.126.025
- Provides a two-wire multiplex bus for the connection of up to 120 remote points
PRODUCT FAMILY
DX2010 Series Input Expander
- Up to eight sensor input loops
- Directly connects to the control panel data bus
PRODUCT FAMILY
DX3010 Series Octo‑output Expander
- Up to eight fully programmable and individual operating outputs
- Remotely mount in a D203 enclosure
DS7000
Splitter for multiplex bus
Commercial Type No.: DS7425 | Product No.: 4.998.143.563
- One-loop input
- Two-loop output
- Two-wire multiplex bus
Handheld Multiplex point programmer
Commercial Type No.: D5060 | Product No.: 4.998.800.202
Steel enclosure, large, grey
Commercial Type No.: D8103 | Product No.: 4.998.800.201
- Easy-to-install standoff location for mounting supported modules
- Easy access locations for battery placement
- Optional tamper switch mounting location
- Made with cold-rolled steel with a gray finish
Transformer, 230/18VAC 45VA, Euro
Commercial Type No.: DE-45-18 | Product No.: F.01U.166.215
- Provides efficient, constant power for compatible products
- For use in Europe