Accessory mounting bracket for enclosure
Commercial Type No.: D137 | Product No.: F.01U.020.521
- Mount accessory modules in B8103, D8103, D8108A, and D8109 enclosures.
Attack resistant enclosure, large
Commercial Type No.: D8108A | Product No.: 4.998.125.920
- 18 gauge cold-rolled steel enclosure
- UL Listed for Central Station Fire, Local Fire, and Remote Station Fire applications
Auxiliary power supply module, 2A 12V
Commercial Type No.: B520 | Product No.: F.01U.172.941
- Provides up to 2 A of 12 V standby current for Fire or Burglar Applications (4 A of Burglary alarm current)
- Supervises up to two 12 V 7-18 Ah batteries independently for up to 36 Ah of capacity
- Provides up to 80 hours of standby time
- Easy-to-read switch addressing
- Uses the Bosch standard TR1850 plug-in transformer
New Solution
Direct link adapter
Commercial Type No.: IUI-SOL-ADAPTER | Product No.: F.01U.292.966
- File configuration
- Firmware upgrade
- Control panel remote control
Door Controller
Commercial Type No.: B901 | Product No.: F.01U.323.803
- Direct interface to compatible Wiegand card readers
- On-board buzzer output and supervised on-board points
- Request to Exit and Request to Enter inputs that can have a shunt only option
- Four door states: Locked, Unlocked, Secured, Fire Unlock
- SDI2 support as well as SDI compatible
PRODUCT FAMILY
DS7432 Series Eight‑input Remote Modules
- Address up to eight input loops
- Serial dual end-of-line (EOL) wiring with tamper status (DS7432E)
PRODUCT FAMILY
DS7457i Series Single‑zone Input Modules
- Power-limited and supervised input zones
- Compact enough to fit within most back boxes and enclosures
- Address settings through DIP switches
Dual tamper switch
Commercial Type No.: ICP-EZTS | Product No.: F.01U.217.038
- Combination tamper switch senses when the opens and if removed from the wall
- Includes a wire loop that can accommodate additional tamper outputs
PRODUCT FAMILY
DX2010 Series Input Expander
- Up to eight sensor input loops
- Directly connects to the control panel data bus
PRODUCT FAMILY
DX3010 Series Octo‑output Expander
- Up to eight fully programmable and individual operating outputs
- Remotely mount in a D203 enclosure
Enclosure lock and key set
Commercial Type No.: D101 | Product No.: 4.998.800.200
- Lock and key set fits Bosch enclosures
Ethernet Communication Module
Commercial Type No.: B426 | Product No.: F.01U.414.222
- Full two-way IP event reporting with remote control panel programming support
- 10/100 Base-T Ethernet communication for IPv6 and IPv4 networks
- NIST-FIPS197 Certified for 128-bit to 256-bit AES Encrypted Line Security
- Plug and Play installation, including UPnP service to enable remote programming behind firewalls
- Advanced configuration by browser, RPS, or A-Link
POPEX
Expansion module, SDI2
Commercial Type No.: B299 | Product No.: F.01U.385.673
- Provides point identification for up to 100 connected addressable initiating devices using POPITs
- Supervises wiring to devices for circuit integrity
- Expands the number of points in the system
- Compact size
- Interconnect wiring connectors for easy installation
Expansion module, SDI2, 8-input
Commercial Type No.: B208 | Product No.: F.01U.397.024
- Programmable input point functions
- Easy to read switch addressing
- 2 interconnect wiring connectors
- Provides eight points
Expansion module, SDI2, 8-output
Commercial Type No.: B308 | Product No.: F.01U.397.025
- Programmable output functions
- Easy to read switch addressing
- Provides eight Form C relays
- 1 A at 5-24 VDC relay contact rating
- Allows remote control of outputs
- Quick modular interconnect wiring connector
Mounting plate, 6 location 3-hole, 5 pcs
Commercial Type No.: D9002-5 | Product No.: F.01U.217.699
- Provides protection and additional mounting options for 3-hole mounted modules
- Mounts in G Series-compatible enclosures
Plug-in Communicator, Telephone
Commercial Type No.: B430 | Product No.: F.01U.414.206
- Provides a single telephone line with RJ-45 connection for central station reporting and remote programming
- Easily configured for communications from Remote Programming Software (RPS) or a keypad, eliminating the need for separate configuration
- Easy two-step plug-in installation, troubleshooting, and maintenance
Steel enclosure, large, grey
Commercial Type No.: D8103 | Product No.: 4.998.800.201
- Easy-to-install standoff location for mounting supported modules
- Easy access locations for battery placement
- Optional tamper switch mounting location
- Made with cold-rolled steel with a gray finish
Steel enclosure, medium, white
Commercial Type No.: B10 | Product No.: F.01U.268.495
- Easy-to-install standoff location for mounting supported modules
- Made with cold-rolled steel with a white semi-gloss finish
- Easy access locations for battery placement
- Optional tamper switch mounting location
Transformer plug-in, 16V 40VA
Commercial Type No.: D1640 | Product No.: 4.998.125.832
- System transformer rated at 16.5 VAC, 40 VA
- Suitable for use on approved UL applications in the USA
Universal enclosure, white
Commercial Type No.: B8103 | Product No.: F.01U.300.149
- Easy-to-install standoff location for mounting supported modules
- Made with cold-rolled steel with a white semi-gloss finish
- Easy access locations for battery placement
- Optional tamper switch mounting location
CONETTIX
USB/serial interface module
Commercial Type No.: DX4010V2 | Product No.: F.01U.080.969
- RS-232/USB connectivity
- Enhanced direct connection for Remote Programming Software (RPS)
- RJ-16 data bus
- Transparent enclosure
- Diagnostic light emitting diodes (LEDs)
- DIP switches for address and bus programming
RADION receiver SD
Wireless SDI2 bus interface
Commercial Type No.: B810 | Product No.: F.01U.383.394
- Dual internal antennas provide spatial and polar RF signal reception for high reliability
- Cover and wall tamper protection
- Multiple device enrollment options as well as RF diagnostics ensure efficient and effective installation
- Supports supervision of wireless points (504), keyfobs (1000), and repeaters (8)
- External status LEDs
- Detection and reporting of radio frequency interference
ZONEX retrofit module
Commercial Type No.: B600 | Product No.: F.01U.383.383
- 3-hole mounting footprint and compact size allow for easy installation
- Provides legacy ZONEX input/output support
- Compact size
- Includes two ZONEX busses allowing for continued ZONEX support on a compatible control panel
PRODUCT FAMILY
RADION keyfob
- Water and dust resistant
- Arm, disarm and panic functions
- Assigned by user for accurate reporting of open close signals
- LED indicator
- Programmable option buttons (only available on 4-button model)
PRODUCT FAMILY
D9127 Series POPIT Modules
- Provides point identification of initiating devices
- Supervises wiring to devices for circuit integrity
- Expands the number of points in the system
- Compact size
- Terminal connections for reliability
- Multiplex technology
- Low installation costs
Handheld Multiplex point programmer
Commercial Type No.: D5060 | Product No.: 4.998.800.202
2-Wire Powered Loop
Commercial Type No.: B201 | Product No.: F.01U.323.798
- Suitable for use with 2-wire smoke detectors and burglary devices
- Supports up to 20 compatible smoke detectors
- Resets latching devices from the control panel
- Connects to the control panel terminal block with easy-to-install integrated pins
Auxiliary relay module, 12/24VDC
Commercial Type No.: D130 | Product No.: 4.998.125.828
- 12 VDC or 24 VDC relay
- Allows switching of current or voltage
- Two non-latching Form C dry contact outputs
- Red LED shows coil is energized
- Mounts in control panel enclosure
Battery, 12V 7Ah
Commercial Type No.: D126 | Product No.: 4.998.125.825
- 12 VDC sealed lead‑acid
- Fully rechargeable
- Maintenance‑free
- For use as secondary power source
- Long service life
DS7000
Dual multiplex driver
Commercial Type No.: DS7436 | Product No.: 4.998.126.025
- Provides a two-wire multiplex bus for the connection of up to 120 remote points
Dual phone line switcher, 12V
Commercial Type No.: D928 | Product No.: 4.998.800.206
- Automatically switches to alternate phone line
- AC Power LED
- Primary and Secondary Phone Trouble LEDs
- Communication Fail LED
Earth ground clamp
Commercial Type No.: D167 | Product No.: F.01U.020.528
- Clamp for earth ground
- Diameter range of 1.3 - 2.5 cm (0.5 - 1 in.)
Metal Enclosure Kit
Metal Enclosure kit w/transformer
Commercial Type No.: B-ENCL-1 | Product No.: F.01U.322.491
- Compatible for B series control panels
- Easy to install standoff locations for mounting supporting modules
- Installed transformer
Mounting plate for D8103 enclosure
Commercial Type No.: B12 | Product No.: F.01U.260.846
- Easy-to-install standoff locations for mounting supported modules
- Supports B Series control panels in larger enclosures such as the D8103
RPS
Programming modem, 2400 baud
Commercial Type No.: MODEM-KIT-2400B | Product No.: 4.998.800.210
- For programming communications
Quick connect cable, SDI2, 10pcs
Commercial Type No.: B501-10 | Product No.: F.01U.268.496
- Cable for quick connection
DS7000
Single Multiplex driver
Commercial Type No.: DS7430 | Product No.: 4.998.800.008
- Provides a two-wire multiplex bus for DS7400Xi Control Panels.
DS7000
Splitter for multiplex bus
Commercial Type No.: DS7425 | Product No.: 4.998.143.563
- One-loop input
- Two-loop output
- Two-wire multiplex bus
Steel enclosure for module, small, grey
Commercial Type No.: D203 | Product No.: 4.998.800.374
- Compatible with input and output modules that have 3-hole or 3-point mountings
- Compatible with Bosch 3-hole mounting modules
- Optional tamper switch mounting location
Steel enclosure, small, white
Commercial Type No.: B11 | Product No.: F.01U.262.005
- Easy to install standoff location for mounting supporting modules
- Made with cold-rolled steel with a white matte finish
- Easy access locations for battery placement
- Optional taper switch mounting location
Transformer, 230/18VAC 45VA, Euro
Commercial Type No.: DE-45-18 | Product No.: F.01U.166.215
- Provides efficient, constant power for compatible products
- For use in Europe
USB direct connect cable
Commercial Type No.: B99 | Product No.: F.01U.278.853
- Allows programming on-site without an Ethernet cable or interface module