FPA‑1000 Analog Addressable Fire Panels
FPA‑1000 Analog Addressable Fire Panels
Fire panel, 2 SLC & networking
Commercial Type No. FPA-1000-V2
Product No. F.01U.213.945
| Supervision | Supervised for the presence of AC power |
| Voltage | 120 VAC, 60 Hz, 1.1 A maximum, or240 VAC, 50 Hz, 0.6 A maximum |
| Voltage | 24 VDC |
| Supervision | Supervised for the presence of AC power |
| Current consumption (standby) | 1.25 A maximum |
| Current consumption (alarm) | 5 A maximum 1.0 A maximum shared between panel and SLC(s) Panel ≤ 250 mA SLC 1 = 60 mA/card + 220 mA/loop maximum SLC 2 = 60 mA/card + 220 mA/loop maximum 4.0 A maximum shared between NACs, Option Bus, and AUX power NACs (non-synchronized) NAC 1 =2.5 A maximum NAC 2 = 2.5 A maximum NACs (synchronized) NAC 1 + NAC 2 in total = 2.75 A maximum Option Bus = 0.5 A maximum AUX/FWR = 0.5 A maximum AUX/RST = = 0.5 A maximum |
| Battery capacity | 7.0 Ah minimum, 40 Ah maximum |
| Charge current | 2.0 A maximum |
| Fuse | 15 A blade-type |
| Suitable battery type | Two 12 VDC in series (7 Ah or 18 Ah in enclosure, 24 Ah or 38 Ah in additional battery box) Recommended Manufacturers: POWER SONIC: PS-1270, PS-12170, PS‑12180 YUASA: NP7-12, NPG18-12 |
| Maintenance | Replace batteries when they fail the Battery Load test |
| AUX/FWR Full Wave Rectified | 500 mA at 24 V FWR (17 to 31 VRMS), non‑switched, power-limited, unfiltered, non‑supervised |
| AUX/RST Resettable | 500 mA at 24 V FWR (17 to 31 VDC), switched, power-limited, filtered, non‑supervised |
| Line impedance for ground fault detection (Option Bus, SLC, NAC, secondary power circuit, City Tie/Local Energy, AUX) | 15 kΩ |
| Voltage | Nominal 12 VDC, power-limited, supervised |
| Current | 500 mA maximum |
| Configuration | 1 Class B |
| Circuit wiring distance | 4000 ft. (1219 m) maximum, depending on wire gage and connected devices |
| Mainboard NACs | Two (NAC 1 and NAC 2) |
| NAC power from panel | Nominal 24 V FWR (17 to 31 VRMS), regulated, power-limited, supervised2.5 A per NAC, maximum current limited to overall 4.0 A shared among AUX power, Option BUS, and NACs |
Analog point programmer, hand-held
Commercial Type No. D5070
Product No. 4.998.800.577
Used to program address settings on EEPROM‑programmable analog devices
Analog sensor base, 4"
Commercial Type No. FAA-325-B4
Product No. F.01U.133.061
Is combined with analog addressable detectors that use the advanced digital communication protocol to provide early fire warning for life safety and property protection
Analog sensor base with sounder, 6"
Commercial Type No. FAA-325-B6S
Product No. F.01U.133.063
Contains an addressable sounder which provides an audible alarm in the immediate vicinity and only works in combination with one of the FAH‑325, FAI-325, or FAP‑325 analog sensors
Analog standard base, 4"
Commercial Type No. FAA-440-B4
Product No. F.01U.163.849
Standard 4-inch base. Used in combination with FAP-440 and FAH-440 detectors to provide early fire warning for life safety and property protection.
Analog heat detector head, fixed/ROR
Commercial Type No. FAH-440
Product No. F.01U.163.842
Use with FAA‑440 family bases and FAP-1000 Analog Addressable Fire Panels to provide general property protection
Analog photoelectric detector head, 24V
Commercial Type No. FAP-440
Product No. F.01U.163.843
Analog photoelectric smoke detector used with FAA‑440 bases and FAP-1000 fire panels
Analog detector head, dual, heat/CO
Commercial Type No. FAP-440-DTC
Product No. F.01U.163.847
Analog dual-photoelectric smoke/heat multi-criteria detector used with FAA‑440 bases and FAP-1000 fire panels
Dual input module for FPA-1000
Commercial Type No. FLM-325-2I4
Product No. F.01U.133.068
Provides two independent contact monitoring circuits to monitor Normally Open (NO) or Normally Closed (NC) dry contact types of fire alarm devices
Dual relay module, 2A
Commercial Type No. FLM-325-2R4-2A
Product No. F.01U.168.098
Provides 2 A current at two independently-controlled Form C contacts for a variety of Normally Open and Normally Closed applications, compatible with 254 addresses
Dual relay module with isolator, 2A
Commercial Type No. FLM-325-2R4-2AI
Product No. F.01U.168.099
Provides 2 A current with built-in short circuit isolator circuitry at two independently-controlled Form C contacts for a variety of Normally Open and Normally Closed applications, compatible with 254 addresses
Dual relay module, 8A
Commercial Type No. FLM-325-2R4-8A
Product No. F.01U.168.100
Provides 8 A current at two independently-controlled Form C contacts for a variety of Normally Open and Normally Closed applications, compatible with 254 addresses
Dual relay module with isolator, 8A
Commercial Type No. FLM-325-2R4-8AI
Product No. F.01U.168.101
Provides 8 A current with built-in short circuit isolator circuitry at two independently-controlled Form C contacts for a variety of Normally Open and Normally Closed applications, compatible with 254 addresses
Conventional zone module for FPA-1000
Commercial Type No. FLM-325-CZM4
Product No. F.01U.133.067
Enables the FACP to interface and monitor up to 25 conventional devices depending on the device type such as two‑wire smoke detectors or pull stations
Contact monitor, class A, 4"
Commercial Type No. FLM-325-I4-A
Product No. F.01U.168.102
Can be wired for Class A or Class B circuits, mounted to a cover plate for a 4‑inch square or double gang electrical back box, bi‑colored LED provides module status, compatible with 254 addresses
Contact monitor with isolator class A 4"
Commercial Type No. FLM-325-I4-AI
Product No. F.01U.168.103
Can be wired for Class A or Class B circuits, has built‑in short circuit isolator circuitry, mounted to a cover plate for a 4‑inch square or double gang electrical back box, bi‑colored LED provides module status, compatible with 254 addresses
Short circuit isolator for FPA-1000
Commercial Type No. FLM-325-ISO
Product No. F.01U.133.071
Isolates a shorted section on a specific polling circuit from the rest of the system to minimize the loss of communication
Supervised output module, Class A/B
Commercial Type No. FLM-325-NA4
Product No. F.01U.168.104
Can be wired for Class A or Class B circuits, compatible with 254 addresses
Supervised output module, isolator, A/B
Commercial Type No. FLM-325-NAI4
Product No. F.01U.168.105
Built-in short circuit isolator circuitry, can be wired for Class A or Class B circuits, compatible with 254 addresses
Analog manual station, single, red
Commercial Type No. FMM-325A
Product No. F.01U.246.085
The single‑action manual station is UL listed for commercial fire applications and meets Americans with Disabilities Act (ADA) requirements. Set the address on the polling circuit by programming an EEPROM microchip with the D5070 Analog point programmer.
Analog manual station, double, red
Commercial Type No. FMM-325A-D
Product No. F.01U.246.087
The double‑action manual station is UL listed for commercial fire applications and meets Americans with Disabilities Act (ADA) requirements. Set the address on the polling circuit by programming an EEPROM microchip with the D5070 Analog point programmer.
LCD annunciator FPA-1000 without control
Commercial Type No. FMR-1000-RA
Product No. F.01U.066.880
LCD annunciator without system control capability for use with the FPA‑1000 Analog Addressable Fire Panels
LCD annunciator FPA-1000 with control
Commercial Type No. FMR-1000-RCMD
Product No. F.01U.066.879
LCD annunciator with system control capability for use with FPA‑1000 Analog Addressable fire Panels
Plug-in SLC module for FPA-1000
Commercial Type No. FPE-1000-SLC
Product No. F.01U.073.062
Provides a Signaling Line Circuit (SLC) for connection of analog devices to the FPA‑1000 Analog Addressable Fire Panels
Analog isolator base, 4"
Commercial Type No. FAA-440-B4-ISO
Product No. F.01U.164.309
4-inch base with built-in isolator. Used in combination with FAP-440 and FAH-440 detectors to provide early fire warning for life safety and property protection.
Analog standard base, 6"
Commercial Type No. FAA-440-B6
Product No. F.01U.164.308
Standard 6-inch base. Used in combination with FAP-440 and FAH-440 detectors to provide early fire warning for life safety and property protection.
Analog isolator base, 6"
Commercial Type No. FAA-440-B6-ISO
Product No. F.01U.164.307
6-inch base with built-in isolator. Used in combination with FAP-440 and FAH-440 detectors to provide early fire warning for life safety and property protection.
Analog photoelectric detector head, 24V
Commercial Type No. FAP-440-T
Product No. F.01U.163.844
Analog photo/heat detector used with FAA‑440 bases and FAP-1000 fire panels
Analog detector head, photo/heat/CO
Commercial Type No. FAP-440-TC
Product No. F.01U.163.846
Analog photo/heat/CO detector used with FAA‑440 bases and FAP-1000 fire panels
Analog dual-photoelectric detector head
Commercial Type No. FAP-440-D
Product No. F.01U.163.820
Analog dual-photoelectric smoke detector used with FAA‑440 bases and FAP-1000 fire panels
Analog detector head, dual, photo/heat
Commercial Type No. FAP-440-DT
Product No. F.01U.163.845
Analog dual-photoelectric smoke/heat multi-sensor detector used with FAA‑440 bases and FAP-1000 fire panels
CO detector (Macurco CM-E1)
Commercial Type No. FCC-380
Product No. F.01U.172.606
Carbon monoxide detector
Network card, 3-Ethernet
Commercial Type No. FPE-1000-NE
Product No. F.01U.213.933
Ethernet Networking Card for peer‑to‑peer communication in an FPA‑1000‑V2 networked system
Network card, 1-Ethernet 2-fiber optic
Commercial Type No. FPE-1000-NF
Product No. F.01U.213.943
Fiber Optic Networking Card for peer‑to‑peer communication in an FPA‑1000 networked system
Network card, 1-Ethernet 2-wired
Commercial Type No. FPE-1000-NW
Product No. F.01U.213.944
Wired Networking Card for peer‑to‑peer communication in an FPA‑1000 networked system
Power supply, RNAC 8A 24V
Commercial Type No. FPP-RNAC-8A-4C
Product No. F.01U.003.444
When connected to a panel’s option bus, the FPP-RNAC-8A-4C adds four additional NFPA 72, Class B or Class A NACs. When connected directly to the NAC output, it is also a NAC power supply for fire-protective signaling systems.
Annunciator, 8 alarm LED
Commercial Type No. D7030X
Product No. 4.998.800.536
Eight zone LEDs indicate alarm conditions.
Annunciator, 8 LED (2 supervisory)
Commercial Type No. D7030X-S2
Product No. 4.998.140.386
Two LEDs indicate supervisory conditions, six indicate alarm conditions.
Annunciator, 8 LED (8 supervisory)
Commercial Type No. D7030X-S8
Product No. 4.998.140.387
All eight zone LEDs (yellow) indicate supervisory conditions.
Annunciator expander, 8 LED
Commercial Type No. D7032
Product No. 4.998.140.388
Use with D7030X Family LED annunciators
Multiplex octal relay module
Commercial Type No. D7035
Product No. 4.998.800.539
Provide eight Form C relay outputs (w/o enclosure) for the D7024, FPD-7024, or FPA‑1000 Fire Alarm Control Panels (FACP)