An error occurred
Welcome back Anonymous. Some items from your previous shopping cart have been restored to your current shopping cart.
PRODUCT FAMILY
D9127 Series POPIT Modules
Available Soon
- Provides point identification of initiating devices
- Supervises wiring to devices for circuit integrity
- Expands the number of points in the system
- Compact size
- Terminal connections for reliability
- Multiplex technology
- Low installation costs
250 in stock
Battery, 12V 7Ah
Commercial Type No.: D126 | Product No.: 4.998.125.825
- 12 VDC sealed lead‑acid
- Fully rechargeable
- Maintenance‑free
- For use as secondary power source
- Long service life
250 in stock
PRODUCT FAMILY
DS7432 Series Eight‑input Remote Modules
- Address up to eight input loops
- Serial dual end-of-line (EOL) wiring with tamper status (DS7432E)
250 in stock
PRODUCT FAMILY
DS7457i Series Single‑zone Input Modules
- Power-limited and supervised input zones
- Compact enough to fit within most back boxes and enclosures
- Address settings through DIP switches
250 in stock
DS7000
Dual multiplex driver
Commercial Type No.: DS7436 | Product No.: 4.998.126.025
- Provides a two-wire multiplex bus for the connection of up to 120 remote points
250 in stock
PRODUCT FAMILY
DX2010 Series Input Expander
- Up to eight sensor input loops
- Directly connects to the control panel data bus
250 in stock
PRODUCT FAMILY
DX3010 Series Octo‑output Expander
- Up to eight fully programmable and individual operating outputs
- Remotely mount in a D203 enclosure
250 in stock
Enclosure lock and key set
Commercial Type No.: D101 | Product No.: 4.998.800.200
- Lock and key set fits Bosch enclosures
250 in stock
Ethernet Communication Module
Commercial Type No.: B426 | Product No.: F.01U.324.383
- Full two-way IP event reporting with remote control panel programming support
- 10/100 Base-T Ethernet communication for IPv6 and IPv4 networks
- NIST-FIPS197 Certified for 128-bit to 256-bit AES Encrypted Line Security
- Plug and Play installation, including UPnP service to enable remote programming behind firewalls
- Advanced configuration by browser, RPS, or A-Link
250 in stock
Expansion module, SDI2, 8-input
Commercial Type No.: B208 | Product No.: F.01U.397.024
- Programmable input point functions
- Easy to read switch addressing
- 2 interconnect wiring connectors
- Provides eight points
250 in stock
Expansion module, SDI2, 8-output
Commercial Type No.: B308 | Product No.: F.01U.397.025
- Programmable output functions
- Easy to read switch addressing
- Provides eight Form C relays
- 1 A at 5-24 VDC relay contact rating
- Allows remote control of outputs
- Quick modular interconnect wiring connector
250 in stock
Handheld Multiplex point programmer
Commercial Type No.: D5060 | Product No.: 4.998.800.202
250 in stock
Mounting plate, 6 location 3-hole, 5 pcs
Commercial Type No.: D9002-5 | Product No.: F.01U.217.699
- Provides protection and additional mounting options for 3-hole mounted modules
- Mounts in G Series-compatible enclosures
250 in stock
RPS
Programming modem, 2400 baud
Commercial Type No.: MODEM-KIT-2400B | Product No.: 4.998.800.210
- For programming communications
250 in stock
PRODUCT FAMILY
RADION keyfob
- Water and dust resistant
- Arm, disarm and panic functions
- Assigned by user for accurate reporting of open close signals
- LED indicator
- Programmable option buttons (only available on 4-button model)
250 in stock
DS7000
Single Multiplex driver
Commercial Type No.: DS7430 | Product No.: 4.998.800.008
- Provides a two-wire multiplex bus for DS7400Xi Control Panels.
250 in stock
Steel enclosure, medium, white
Commercial Type No.: B10 | Product No.: F.01U.268.495
- Easy-to-install standoff location for mounting supported modules
- Made with cold-rolled steel with a white semi-gloss finish
- Easy access locations for battery placement
- Optional tamper switch mounting location
250 in stock
Steel enclosure, small, white
Commercial Type No.: B11 | Product No.: F.01U.262.005
- Easy to install standoff location for mounting supporting modules
- Made with cold-rolled steel with a white matte finish
- Easy access locations for battery placement
- Optional taper switch mounting location
250 in stock
CONETTIX
USB/serial interface module
Commercial Type No.: DX4010V2 | Product No.: F.01U.080.969
- RS-232/USB connectivity
- Enhanced direct connection for Remote Programming Software (RPS)
- RJ-16 data bus
- Transparent enclosure
- Diagnostic light emitting diodes (LEDs)
- DIP switches for address and bus programming
250 in stock
RADION receiver SD
Wireless SDI2 bus interface
Commercial Type No.: B810 | Product No.: F.01U.383.394
- Dual internal antennas provide spatial and polar RF signal reception for high reliability
- Cover and wall tamper protection
- Multiple device enrollment options as well as RF diagnostics ensure efficient and effective installation
- Supports supervision of wireless points (504), keyfobs (1000), and repeaters (8)
- External status LEDs
- Detection and reporting of radio frequency interference
250 in stock
POPEX
Octo-output module, form C relays
Commercial Type No.: D8129 | Product No.: 4.998.800.198
- Programmable relay functions
- Provides eight Form C relays
- 1 A at 30 VDC relay contact rating
- Slide switch configuration
- Allows remote control of relays
- Screw terminal connections
250 in stock
POPEX
Octo-POPIT input module
Commercial Type No.: D8128D | Product No.: 4.998.800.197
- Provides point identification for initiating devices
- Expands the number of points in the system
- DIP switch programmable
250 in stock
DS7000
Splitter for multiplex bus
Commercial Type No.: DS7425 | Product No.: 4.998.143.563
- One-loop input
- Two-loop output
- Two-wire multiplex bus
250 in stock
Steel enclosure, large, grey
Commercial Type No.: D8103 | Product No.: 4.998.800.201
- Easy-to-install standoff location for mounting supported modules
- Easy access locations for battery placement
- Optional tamper switch mounting location
- Made with cold-rolled steel with a gray finish
250 in stock
POPEX
Expansion module
Commercial Type No.: D8125 | Product No.: F.01U.383.282
- Provides point identification of initiating devices
- Supervises wiring to devices for circuit integrity
- Expands the number of points in the system
- Compact size
- Terminal connections for reliability
250 in stock
POPEX
Expansion module, Multiplex
Commercial Type No.: D8125MUX | Product No.: F.01U.383.283
- Multiplex bus controls two independent class-B buses
- Aux Power terminals that can be used for remote devices
- Programmed with D5060 Handheld Programmer
- Operation monitoring LED
- Connect to Zonex 1 or Zonex 2
- Standard three hole mounting
- Accepts Daisy Chain and T-Tapping bus configurations
250 in stock
POPEX
Expansion module, SDI2
Commercial Type No.: B299 | Product No.: F.01U.385.673
- Provides point identification for up to 100 connected addressable initiating devices using POPITs
- Supervises wiring to devices for circuit integrity
- Expands the number of points in the system
- Compact size
- Interconnect wiring connectors for easy installation
250 in stock
Metal Enclosure Kit
Metal Enclosure kit w/transformer
Commercial Type No.: B-ENCL-1 | Product No.: F.01U.322.491
- Compatible for B series control panels
- Easy to install standoff locations for mounting supporting modules
- Installed transformer
250 in stock
ZONEX retrofit module
Commercial Type No.: B600 | Product No.: F.01U.383.383
- 3-hole mounting footprint and compact size allow for easy installation
- Provides legacy ZONEX input/output support
- Compact size
- Includes two ZONEX busses allowing for continued ZONEX support on a compatible control panel
250 in stock
Showing of 29 Items
Added to Your Shopping Cart