2-Wire Powered Loop
Commercial Type No.: B201 | Product No.: F.01U.323.798
- Suitable for use with 2-wire smoke detectors and burglary devices
- Supports up to 20 compatible smoke detectors
- Resets latching devices from the control panel
- Connects to the control panel terminal block with easy-to-install integrated pins
Auxiliary power supply module, 2A 12V
Commercial Type No.: B520 | Product No.: F.01U.172.941
- Provides up to 2 A of 12 V standby current for Fire or Burglar Applications (4 A of Burglary alarm current)
- Supervises up to two 12 V 7-18 Ah batteries independently for up to 36 Ah of capacity
- Provides up to 80 hours of standby time
- Easy-to-read switch addressing
- Uses the Bosch standard TR1850 plug-in transformer
Battery, 12V 7Ah
Commercial Type No.: D126 | Product No.: 4.998.125.825
- 12 VDC sealed lead‑acid
- Fully rechargeable
- Maintenance‑free
- For use as secondary power source
- Long service life
Door Controller
Commercial Type No.: B901 | Product No.: F.01U.323.803
- Direct interface to compatible Wiegand card readers
- On-board buzzer output and supervised on-board points
- Request to Exit and Request to Enter inputs that can have a shunt only option
- Four door states: Locked, Unlocked, Secured, Fire Unlock
- SDI2 support as well as SDI compatible
PRODUCT FAMILY
DS7432 Series Eight‑input Remote Modules
- Address up to eight input loops
- Serial dual end-of-line (EOL) wiring with tamper status (DS7432E)
PRODUCT FAMILY
DS7457i Series Single‑zone Input Modules
- Power-limited and supervised input zones
- Compact enough to fit within most back boxes and enclosures
- Address settings through DIP switches
DS7000
Dual multiplex driver
Commercial Type No.: DS7436 | Product No.: 4.998.126.025
- Provides a two-wire multiplex bus for the connection of up to 120 remote points
Dual tamper switch
Commercial Type No.: ICP-EZTS | Product No.: F.01U.217.038
- Combination tamper switch senses when the opens and if removed from the wall
- Includes a wire loop that can accommodate additional tamper outputs
Enclosure lock and key set
Commercial Type No.: D101 | Product No.: 4.998.800.200
- Lock and key set fits Bosch enclosures
Ethernet Communication Module
Commercial Type No.: B426 | Product No.: F.01U.414.222
- Full two-way IP event reporting with remote control panel programming support
- 10/100 Base-T Ethernet communication for IPv6 and IPv4 networks
- NIST-FIPS197 Certified for 128-bit to 256-bit AES Encrypted Line Security
- Plug and Play installation, including UPnP service to enable remote programming behind firewalls
- Advanced configuration by browser, RPS, or A-Link
Expansion module, SDI2, 8-input
Commercial Type No.: B208 | Product No.: F.01U.397.024
- Programmable input point functions
- Easy to read switch addressing
- 2 interconnect wiring connectors
- Provides eight points
Expansion module, SDI2, 8-output
Commercial Type No.: B308 | Product No.: F.01U.397.025
- Programmable output functions
- Easy to read switch addressing
- Provides eight Form C relays
- 1 A at 5-24 VDC relay contact rating
- Allows remote control of outputs
- Quick modular interconnect wiring connector
Plug-in Communicator, Telephone
Commercial Type No.: B430 | Product No.: F.01U.414.206
- Provides a single telephone line with RJ-45 connection for central station reporting and remote programming
- Easily configured for communications from Remote Programming Software (RPS) or a keypad, eliminating the need for separate configuration
- Easy two-step plug-in installation, troubleshooting, and maintenance
PRODUCT FAMILY
RADION keyfob
- Water and dust resistant
- Arm, disarm and panic functions
- Assigned by user for accurate reporting of open close signals
- LED indicator
- Programmable option buttons (only available on 4-button model)
Steel enclosure for module, small, grey
Commercial Type No.: D203 | Product No.: 4.998.800.374
- Compatible with input and output modules that have 3-hole or 3-point mountings
- Compatible with Bosch 3-hole mounting modules
- Optional tamper switch mounting location
Steel enclosure, medium, white
Commercial Type No.: B10 | Product No.: F.01U.268.495
- Easy-to-install standoff location for mounting supported modules
- Made with cold-rolled steel with a white semi-gloss finish
- Easy access locations for battery placement
- Optional tamper switch mounting location
Transformer plug-in, 16V 40VA
Commercial Type No.: D1640 | Product No.: 4.998.125.832
- System transformer rated at 16.5 VAC, 40 VA
- Suitable for use on approved UL applications in the USA
Universal enclosure, white
Commercial Type No.: B8103 | Product No.: F.01U.300.149
- Easy-to-install standoff location for mounting supported modules
- Made with cold-rolled steel with a white semi-gloss finish
- Easy access locations for battery placement
- Optional tamper switch mounting location
USB direct connect cable
Commercial Type No.: B99 | Product No.: F.01U.278.853
- Allows programming on-site without an Ethernet cable or interface module
CONETTIX
USB/serial interface module
Commercial Type No.: DX4010V2 | Product No.: F.01U.080.969
- RS-232/USB connectivity
- Enhanced direct connection for Remote Programming Software (RPS)
- RJ-16 data bus
- Transparent enclosure
- Diagnostic light emitting diodes (LEDs)
- DIP switches for address and bus programming
RADION receiver SD
Wireless SDI2 bus interface
Commercial Type No.: B810 | Product No.: F.01U.383.394
- Dual internal antennas provide spatial and polar RF signal reception for high reliability
- Cover and wall tamper protection
- Multiple device enrollment options as well as RF diagnostics ensure efficient and effective installation
- Supports supervision of wireless points (504), keyfobs (1000), and repeaters (8)
- External status LEDs
- Detection and reporting of radio frequency interference
PRODUCT FAMILY
DS7433 Series Eight‑input Modules
- Expand up to 16 hard-wired control panel points
- Compatible with DS7400Xi Series Control Panels
Accessory mounting bracket for enclosure
Commercial Type No.: D137 | Product No.: F.01U.020.521
- Mount accessory modules in B8103, D8103, D8108A, and D8109 enclosures.
Battery, 12V 10-12Ah
Commercial Type No.: IPS-BAT12V-12AH | Product No.: F.01U.579.778
- Lead battery
- Shock-resistant plastic enclosure
- Dry-cell battery
- Can be used irrespective of its position
- Low self-discharge
Battery, 12V 17-18Ah
Commercial Type No.: IPS-BAT12V-18AH | Product No.: F.01U.579.780
- Lead battery
- Shock-resistant plastic enclosure
- Dry-cell battery
- Can be used irrespective of its position
- Low self-discharge
Battery, 12V 2.2Ah
Commercial Type No.: D1222 | Product No.: 4.998.125.821
- 12 VDC sealed lead‑acid
- Fully rechargeable
- Maintenance‑free
- Long service life
- Appropriate for use as uninterruptible power supplies
Battery, 12V 24-27Ah
Commercial Type No.: IPS-BAT12V-27AH | Product No.: F.01U.579.781
- Lead battery
- Shock-resistant plastic enclosure
- Dry-cell battery
- Can be used irrespective of its position
- Low self-discharge
Battery, 12V 38-45Ah
Commercial Type No.: IPS-BAT12V-45AH | Product No.: F.01U.579.782
- Lead battery
- Shock-resistant plastic enclosure
- Dry-cell battery
- Can be used irrespective of its position
- Low self-discharge
Blocking element
Commercial Type No.: 4998149110 | Product No.: 4.998.149.110
- additional lock for a door
- prevents unauthorized entry to an armed area
Dual battery harness
Commercial Type No.: D122 | Product No.: 4.998.800.378
- Used for batteries in parallel
- Slide-on connectors
- Built-in circuit breaker protection
Earth ground clamp
Commercial Type No.: D167 | Product No.: F.01U.020.528
- Clamp for earth ground
- Diameter range of 1.3 - 2.5 cm (0.5 - 1 in.)
DS7000
Input module, dual-zone
Commercial Type No.: DS7460I | Product No.: 4.998.113.231
- Supervises two protection loops
- Can be used in UL Listed fire and security applications
- DIP switch programmable
Low battery disconnect module
Commercial Type No.: D135A | Product No.: 4.998.125.829
- Disconnects a B6512/B5512/B4512/B3512 from the battery when the battery level drops to 9.5 VDC
- Required for use with compatible control panels for CAN/ULC S559
- Quick and easy installation
LSN Power supply, NEV400
Commercial Type No.: ISP-NEV400-120 | Product No.: F.01U.308.346
- Provides a remote power supply
- Transmits trouble and tamper events via LSN
- Can be connected to all centralized or decentralized LSN control panels
- A maximum of two 12 V/18 Ah batteries can be used
Mounting plate for D8103 enclosure
Commercial Type No.: B12 | Product No.: F.01U.260.846
- Easy-to-install standoff locations for mounting supported modules
- Supports B Series control panels in larger enclosures such as the D8103
Mounting plate, 6 location 3-hole, 5 pcs
Commercial Type No.: D9002-5 | Product No.: F.01U.217.699
- Provides protection and additional mounting options for 3-hole mounted modules
- Mounts in G Series-compatible enclosures
DS7000
Multiplex module, single input
Commercial Type No.: DS7457IE | Product No.: 4.998.140.244
- Power-limited and supervised input zones
- Compact enough to fit within most back boxes and enclosures
- Address settings through DIP switches
PRODUCT FAMILY
Power Supplies IPS Series
- Linear power supplies
- Tamper switch provided
- Possibility to carry back up power in the enclosure
- Battery test easily operated from outside
- Recharging back up battery
- LED indicators
Powered loop interface
Commercial Type No.: D125B | Product No.: 4.998.800.203
- Two separate powered detector loops
- Suitable for 12 VDC or 24 VDC, two‑wire or four‑wire detectors
- Up to 50 two‑wire 12 VDC glass break detectors
- Reports individual loop alarm, individual loop trouble, and ground fault
- Manually resets latching devices from control panel or remote central station
Quick connect cable, SDI2, 10pcs
Commercial Type No.: B501-10 | Product No.: F.01U.268.496
- Cable for quick connection
DS7000
Single input/output module
Commercial Type No.: DS7465I | Product No.: 4.998.113.233
- Supervises one power-limited input zone
- Provides one output relay
- Can be used in UL Listed fire and security applications
- DIP switch programmable
DS7000
Single Multiplex driver
Commercial Type No.: DS7430 | Product No.: 4.998.800.008
- Provides a two-wire multiplex bus for DS7400Xi Control Panels.
Tamper switch for enclosure, 2pcs
Commercial Type No.: D110 | Product No.: F.01U.246.707
- Tamper switch fits all enclosures
Transformer, 230/18VAC 45VA, Euro
Commercial Type No.: DE-45-18 | Product No.: F.01U.166.215
- Provides efficient, constant power for compatible products
- For use in Europe