Bosch Security and Safety Systems | Latin America
Product Variants
Product Families
More Content
Break rods, scored acrylic, 12pcs
CTN: FMM-100GR | Product No.: 4.998.155.098
- Scored for clean breaking
- Lightweight acrylic
- Comes in packages of 12
250 in stock
PRODUCT FAMILY
D7035 Octal Relay Modules
- Provides eight Form C programmable relay outputs
- Module connects to the FACP’s option bus
- D7035 mounts conveniently inside the FACP enclosure with no separate enclosure needed
- D7035B includes mounting skirt and enclosure for mounting outside of the FACP enclosure
- Up to two modules are supported by the FACP
250 in stock
PRODUCT FAMILY
FMM‑325A Analog Manual Stations
- Digital data communications and power provided over two-wire circuit
- EEPROM addressing in module unit
- Rugged die‑cast housing and corrosion resistant construction
- Single‑gang mounting
- Latching alarm lever
- UL listed for commercial fire applications
- Meets Americans with Disabilities Act (ADA) requirements
250 in stock
Plug-in SLC module for FPA-1000
CTN: FPE-1000-SLC | Product No.: F.01U.073.062
- Signaling Line Circuit (SLC) is power-limited and supervised
- Configurable as one Class X or Class A or two Class B circuits
- Up to 254 detectors and modules, or 127 analog sounder bases in combination with suitable detectors
250 in stock
Remote indicator plate
CTN: D304 | Product No.: 4.998.125.873
- Green pilot LED, red alarm LED
- Use single‑gang back box
250 in stock
Remote test/indicator plate, 24V
CTN: D305 | Product No.: F.01U.020.620
- Keyed test/reset switch
- Green pilot LED, red alarm LED
- Uses single‑gang back box
250 in stock
Sample tube, duct 10'/304.8cm
CTN: FAA-325-10 | Product No.: F.01U.133.077
- Metal tube with air sampling holes
- Tubes connect to each other and to housing using standard ½” collets
- End plug provided
250 in stock
Sample tube, duct 2.5'/76.2cm
CTN: FAA-325-2.5 | Product No.: F.01U.133.075
- Metal tube with air sampling holes
- Tubes connect to each other and to housing using standard ½” collets
- End plug provided
250 in stock
Sample tube, duct 5'/152.4cm
CTN: FAA-325-5 | Product No.: F.01U.133.076
- Metal tube with air sampling holes
- Tubes connect to each other and to housing using standard ½” collets
- End plug provided
250 in stock
Surface backbox, 4.75x3.25x2.25", red
CTN: FMM-100BB-R | Product No.: F.01U.000.557
- Red sheet-metal back box for interior surface-mount applications
- Knockouts (1/2-inch) on the short sides
250 in stock
Weatherproof backbox 4.75x3.25x2.25" red
CTN: FMM-100WPBB-R | Product No.: F.01U.000.561
- Weatherproof cast metal back box
- Tapped hole for ¾‑in. NPT fitting
- Easy to install
250 in stock
Analog sensor base with sounder, 6"
CTN: FAA-325-B6S | Product No.: F.01U.133.063
- Sound pressure level of 85 dB at 10 ft
- Can be alarmed by zone or by host
- Base learns the detector address and adds 127 to it (address range from 128‑254)
- Digital data communications via the attached detector and powered over a four‑conductor circuit
250 in stock
Analog sensor base, 4"
CTN: FAA-325-B4 | Product No.: F.01U.133.061
- Modular design
- Small and robust detector base with same diameter as detectors
- Easy detector removal for cleaning and servicing
- Stable fixing of detectors
- Terminal screws for remote LED, Data In and Out provided
250 in stock
Analog sensor base, 6"
CTN: FAA-325-B6 | Product No.: F.01U.133.062
- Modular design
- Robust six‑inch detector base
- Easy sensor removal for cleaning and servicing
- Stable mounting of sensors
- Terminal screws for remote LED, Data In and Out provided
250 in stock
Contact monitor for mounting in backbox
CTN: FLM-325-IM | Product No.: F.01U.216.136
- Digital data communications and power provided over a two-wire circuit
- Class B circuit for dry contact devices
- Module address programming (1-254) with the D5070 Analog Device Programmer
250 in stock
Conventional zone module for FPA-1000
CTN: FLM-325-CZM4 | Product No.: F.01U.133.067
- Provides a zone of up to 25 conventional smoke detectors (depending on detector type)
- Supervises auxiliary power supply for conventional detectors
- Compatible with Class B (Style B) or Class A (Style D)
- Module address programming with the D5070 Analog Device Programmer between 1 and 127
- Bi‑colored LED provides module status
- Digital data communications and power over a four‑wire circuit
250 in stock
PRODUCT FAMILY
D7048/D7048B Octal Driver Modules
- Compatible with the D7024, FPD-7024, or FPA‑1000 FACPs
- D7048 mounts inside the FACP enclosure; no separate enclosure needed
- D7048B includes mounting skirt and red metal enclosure for mounting outside of the FACP enclosure
- Each driver output is fully programmable
- Up to two modules are supported by the FACP
250 in stock
Dual input module for FPA-1000
CTN: FLM-325-2I4 | Product No.: F.01U.133.068
- Two independent contact monitoring circuits
- Monitors Normally Open (NO) or Normally Closed (NC) contacts
- Monitored Normally Open (NO) contacts can be configured with or without EOL resistor
- Module address programming with the D5070 Analog Device Programmer between 1‑127
- Bicolored LED provides module status
- Digital data communications and power over a two‑wire circuit
250 in stock
PRODUCT FAMILY
FLM-325-2R4-A Dual Relay Modules Family Datasheet
- Provides 8 A of current with built-in short circuit isolator circuitry
- Two independently configurable Form C contacts
- Contacts are rated 1 A at 30 VDC or 0.5 A at 125 VAC
- Module address programming with the D5070 Analog Device Programmer
- Bi‑colored LED provides module status
- Digital data communications and power over a two‑wire circuit
250 in stock
PRODUCT FAMILY
FLM-325-I4-A Contact Monitors
- Monitors Normally Open (NO) or Normally Closed (NC) contacts
- Monitored Normally Closed (NC) contacts can be configured with or without EOL resistor
- Module address programming with the D5070 Analog Device Programmer
- Bi‑colored LED provides module status
- Digital data communications and power over a two‑wire circuit
- EEPROM addressing
250 in stock
PRODUCT FAMILY
FLM-325-NA4 Supervised Output Modules
- Contacts are rated 2 A at 24 VDC
- Flexible application and quick response to emergency conditions
- Can be alarmed or reset by zone or by individual address
- Module address programming with the D5070 Analog Device Programmer
- Bi‑colored LED provides module status
- Digital data communications and power over a four‑wire circuit
250 in stock
PRODUCT FAMILY
FPA‑1000 Analog Addressable Fire Panels
- Support for up to 508 points on two analog addressable loops
- Built-in Ethernet connector for web-browser based programming and Conettix Alarm-over-IP communication
- Two on-board NACs and dual-line PSTN DACT
- Peer-to-peer networking of up to eight -V2 panels in a single group
- Suited to a wide range of applications and compatible with the latest Bosch solutions - including 440 Series Multi-criteria detectors
- Simple system management and free online training
- Variety of communication channels
- Gas detection
250 in stock
LCD annunciator FPA-1000 with control
CTN: FMR-1000-RCMD | Product No.: F.01U.066.879
- LED status indicators
- 80‑character LCD display
- Piezo sounder
- Navigation buttons
- Operations keys for drill, reset, silence, and acknowledge
250 in stock
LCD annunciator FPA-1000 without control
CTN: FMR-1000-RA | Product No.: F.01U.066.880
- LED status indicators
- 80‑character LCD display
- Piezo sounder
- Navigation buttons
- Acknowledge key
250 in stock
Network card, 1-Ethernet 2-fiber optic
CTN: FPE-1000-NF | Product No.: F.01U.213.943
- Provides media type change through RJ45 and fiber optic connections
- Provides one Ethernet port using CAT 5 or better cable
- Uses simple plug-in connection to the FPA‑1000‑V2
- Connects as either Class A or Class B
- Provides second power input port for normal network operation during maintenance
250 in stock
Network card, 1-Ethernet 2-wired
CTN: FPE-1000-NW | Product No.: F.01U.213.944
- Provides media type change through RJ45 and wired connections
- Provides one Ethernet port using CAT 5 or better cable
- Uses simple plug-in connection to the FPA‑1000‑V2
- Connects as either Class A or Class B
- Provides second power input port for normal network operation during maintenance
250 in stock
Network card, 3-Ethernet
CTN: FPE-1000-NE | Product No.: F.01U.213.933
- Provides three Ethernet ports using CAT 5 or better cable
- Uses simple plug-in connection to the FPA‑1000‑V2
- Connects as either Class A or Class B
- Uses standard RJ45 connections
- Provides second power input port for normal network operation during maintenance
250 in stock
Plug-in city tie module for FPA-1000
CTN: FPE-1000-CITY | Product No.: F.01U.076.985
- Provides two supervised City Tie Local Energy circuits or Reverse Polarity circuits
- Connects to a Master Box (Local Energy Mode) or Central Station (Reverse Polarity Mode)
250 in stock
Short circuit isolator for FPA-1000
CTN: FLM-325-ISO | Product No.: F.01U.133.071
- Automatic verification of data line for short circuit
- Contacts are rated to 1 A at 30 VDC
- Can be placed at any location on SLC loop
- 256 devices at maximum per loop for Class A (Style 7)
- Yellow LED provides data line status
250 in stock
Showing of 29 Items
Added to Your Shopping Cart